Great Compatibility – Works on Detroit Diesel Series 60 and two Cycle 92 engines. Functional Use – Used to install the front and rear crankshaft wear sleeves and seals, eliminating lip flare on the wear sleeve and installing the seals properly without any leakage, which saves you a lot of trouble during work. Premium Material – Features top high quality CNC solid steel construction with a slick black finish, durable and anti corrosion, repeatedly tested and gradually optimized to ensure its excellent performance and lasting service time. Direct Replacement – Alternative to J-35686 & J-35686-A & #J-35686-B, widely used on multiple seal & wear sleeve assemblies including 23516969, 23513578, 23513485, 23518355. Satisfaction Guarantee – We are dedicated to offering the best quality product for our valued customers. For use on Detroit Diesel Series 60 and two cycle 92. Use on seal # 23516969 23513578 23513485 23518355. Installs front crankshaft seal. Installs front crankshaft wear sleeve. Install old seal p/n- 23513485 and new seal p/n- 23518355 front seals and p/n 23516969 & 23513578 rear seal and wear sleeve. Lubricate the rubber outer diameter of the oil seal with clean engine oil. Lubricate the gear case cover or flywheel housing bore with clean engine oil. Install two guide studs (J-35686-2) through the holes provided in the center guide assembly (J-35686-1) and into two of the tapped holes in the crankshaft 180 degrees apart. Tighten the guide studs. The base must be tight against the end of the crankshaft. Install the spacers to the center screw of the base. Slide the oil seal assembly over the installer base as far onto the crankshaft hub as possible. Slide collar with the stepped side contacting the seal. Slide the installer cup over the guide studs and installer base. Lubricate the center screw of the base with extreme pressure lubricant. Install the thrust bearing with the case side toward the installer cup and install the hex nut to the center screw of the base. Tighten the hex nut until the oil seal and wear sleeve are pressed into the flywheel housing or gear case cover. When the inside surface of the housing is seated firmly against the base and spacers the seal and sleeve are properly installed. J-35686-B Seal and Wear Sleeve Installer. This item is in the category “eBay Motors\Automotive Tools & Supplies\Hand Tools\Other Automotive Hand Tools”. The seller is “linahu88″ and is located in this country: US. This item can be shipped to United States.
- Brand: Unbranded
- Type: Front & Rear Crankshaft Seal & Wear Sleeve Installer Too
- Warranty: 1 Year
- Fitment: For Detroit Diesel Series 60