J-35686-B 5887 Front & Rear Crankshaft Oil Seal and Oil. Sleeve Installer Compatible with Detroit Diesel Series 60. Two Cycle 92 Engines. Works on Detroit Diesel Series 60 and two Cycle 92 engines. Used to install the front and rear crankshaft wear sleeves and seals, eliminating lip flare on the wear sleeve and installing the seals properly without any leakage, which saves you a lot of trouble during work. Features top high quality CNC solid steel construction with a slick black finish, durable and anti corrosion, repeatedly tested and gradually optimized to ensure its excellent performance and lasting service time. Alternative to J-35686 & J-35686-A & #J-35686-B, widely used on multiple seal & wear sleeve assemblies including 23516969, 23513578, 23513485, 23518355. Lubricate the rubber outer diameter of the oil seal with clean engine oil. Lubricate the gear case cover or flywheel housing bore with clean engine oil. Failure to lubricate the outside of the seal and the inside of the bore prior to installation may damage seal causing seal to leak. Install two guide studs (J-35686-2, part of tool set J-35686-B) through the holes provided in the center guide assembly (J-35686-1, part of tool set J-35686-B) and into two of the tapped holes in the crankshaft 180 degrees apart. Tighten the guide studs using the appropriate wrench on the flats of the studs. The base must be tight against the end of the crankshaft. Install the spacers to the center screw of the base. Slide the oil seal assembly over the installer base as far onto the crankshaft hub as possible. Slide collar with the stepped side contacting the seal. Slide the installer cup over the guide studs and installer base. Lubricate the center screw of the base with extreme pressure lubricant (J-23444-A, part of tool set J-41329). Install the thrust bearing with the case side toward the installer cup and install the hex nut to the center screw of the base. Finger tighten the hex nut until snug. Install a ratchet and socket onto the hex nut. Tighten the hex nut until the oil seal and wear sleeve are pressed into the flywheel housing or gear case cover. When the inside surface of the housing is seated firmly against the base and spacers the seal and sleeve are properly installed. Measure the face squareness of the outside diameter of the crankshaft seal using a runout gage installed on the crankshaft. If the total indicator reading is more then 0.762 mm 0.030 in. The seal must be removed and a new seal installed. It is important that we know when your return is expected. We need this in case there are any issues during transit. Welcome to our store! We will reply your message within 24 hours Mon-Sat, and 48 hours on Sunday. We will do our best to solve the problem, thanks! This item is in the category “eBay Motors\Automotive Tools & Supplies\Other Auto Tools & Supplies”. The seller is “desielparts-international” and is located in this country: US. This item can be shipped worldwide.
- Type: Crank Seal Installer
- Manufacturer Part Number: BON-J-35686-B
- Brand: Bonbo
- Warranty: 1 Year
- Material: Steel
- Color: Black
- Fitment: for Detroit Diesel Series 60 Two Cycle 92 Engines