Turbo Turbocharger For International Detroit Diesel Series 60 Engine 11.1L 96-05
Turbo Turbocharger For International Detroit Diesel Series 60 Engine 11.1L 96-05. Please check the Turbo Model, Turbo Part Number and OEM Part Number on your turbo to make sure it’s the right one for your engine. Before fitting the turbocharger. Use new and approved gaskets at the various air, oil and exhaust connections to the turbocharger. Liquid gasket or sealants are not recommended, particularly for oil fittings. Use a high temperature anti-seize compound on all threaded fasteners connected to the turbocharger. Fill the turbocharger oil inlet port to overflowing with clean engine oil before connecting the oil feed hose. When fitting the turbocharger to the manifold and connecting the respective pipes. Before connecting the oil drain hose, crank the engine without firing until steady stream of oil flows from the drain port. Operate the engine at low idle for at least three minutes after completing the installation of turbocharger. This will prevent oil starvation damage to the bearing system. Misuse or modification of the turbocharger can result in serious injury and property damage. Basic safety precautions including the following should always be followed. Read and comply with all instructions including the “Checklist ” before installing or using any turbocharger. Failure to follow these instructions will lead to premature failure of the turbocharger. Only install the turbocharger on an engine which has been approved for such application. The turbocharger is a precision built product which has been matched and tested for use on specific engines only. No part of the turbocharger may be altered as it may damage the engine. Do not modify or substitute any parts of engine except in accordance with engine owner’s manual. Do not modify the engine fuel control system or restrict the inlet or exhaust system (see engine owner’s manual). Do not operate at excessive altitudes (consult Engine Owner’s Manual for altitude restrictions). Be sure that oil supply and drain lines are adequate. Always warm up the engine for 2-5minutes to allow oil to reach the turbocharger before operating under load. Concurrently inspect turbocharger for any deficiencies. Please check the Part Number and OEM Part Number to make sure it’s the right one for your model. Communication is the best way to solve the problem. TOPAZ Auto Parts Inc. All we ask is you send it back in the same condition it was received – new and un-used. Logistical claims must be filed within 30 days of received the product; exchanges in these cases will be handled promptly and at no cost to the customer. However, any return that is NOT defective or NOT received in error, is the responsibility of the customer. We are a Auto aftermaket Parts Team with over 20 years’ experiences in the automotive business. Our passion for auto parts, and drive to provide EXEMPLARY Customer Servive, set us apart from the competition. Our friendly staff are available during these hours.