Turbo for Detroit Diesel Truck 12.7L Series 60 For Borg Warner KKK K31 172743. For Caterpillar for CAT C12 & Detroit Diesel Series 60 Engine. Due to the color difference of the display, the received items may be a little different from the color on the picture, please know in advance! YOU MAY ALSO LIKE. New Rebuild Repair Kits for Detroit Series 60 Borg WarnerK 31 Turbo 12.7L 172743. New For 12.7L Detroit Diesel Truck Series 60 BorgWarner K31 Turbo Turbine Shaft. New Actuator For Detroit Diesel Truck 12.7L Series 60 Borg Warner K31 Turbo. New Detroit Series 60 Borg WarnerK 31 Turbocharger 12.7L Engine 172743 23528062. Lower 48 states with physical address. An 5% additional charge will be apply on American Express users. Parts must be in new, re-salable condition. If a part arrives damaged, or is defective, we can help you to take care of it but it must be reported to us immediately. Please be patient if your inquiry requires further investigation. Business Hour: 8:30am – 5:00pm Monday through Friday. Once you have received your item, please leave feedback for us as this will inform us that you have received your items. When re-installing the turbo, be sure that you take out any rags anything else you used to block off any inlets or intercooler hoses. Your old turbo’s Demise. But if you killed a fairly new turbo for no apparent reason, think about what could have been the cause of the turbo’s failure. If you simply bolt on a new turbo without fixing the problem, don’t expect your new turbo to live long either. The Shaft is Rocky. There is a gap between the shaft and sleeve and a gap between the sleeve and housing. These two gaps combined allow the compressor wheel tip to move side to side in what may look like an alarming amount. As long as the wheel is not touching the housing, you are fine. There should be no play axially (in and out) with the compressor wheel and shaft. You were doing some grinding or porting near the motor with the turbo removed. You blocked off the turbo oil drain pipe with a piece of tape. You forget to take the piece of tape and install the turbo. Start it up and instant James Bond smoke. The oil flow into the turbo has nowhere to go and gets pumped out the bearing seals. If your turbo does this, check the oil drain for blockage, remove it and start it up again. The turbo will be fine, it will take a few minutes of driving to burn out all the oil from the exhaust system. Also a plugged up crank case vent will cause excessive pressure to build up in the crankcase. This prevents the oil from draining out of the turbo and blows the excess oil out through the turbo seals. Add to Favorite Sellers. Please give us five-star feedback, if you accept our products and services, thank you very much!