Detroit Diesel Series 60 Tool Lot Kent-Moore J-35906 J-35996-A J-44706 Snap-on DETROIT DIESEL SERIES 60 SPECIALTY TOOL COLLECTION Genuine Kent-Moore, Snap-on, and the complete factory service manual set. Three genuine American-made Kent-Moore tools, a four-piece Snap-on injector height gauge set, the factory service manual, and supporting tooling. Everything you see in the photos is included. KENT-MOORE J-35906 CAM GEAR PILOT, COMPLETE KIT Triangular alignment plate stamped J-35906 KENT-MOORE USA, plus BOTH shouldered puller bolts. KENT-MOORE J-35996-A ROCKER ARM SHAFT LIFTER. Stamped J-35996-A KENT-MOORE USA 64E. KENT-MOORE J-44706 ROCKER ARM SHAFT SOCKET. Stamped J-44706 KENT-MOORE U. SNAP-ON INJECTOR HEIGHT GAUGE SET, 4 PIECES Long discontinued by Snap-on. ADJUSTABLE INJECTOR HEIGHT GAUGE Knurled handle with adjustable head stamped 80.3, 81.0, 82.1, part number 519744. DETROIT DIESEL SERIES 60 SERVICE MANUAL, COMPLETE 2-VOLUME SET Original factory manual, publication 6SE483, dated January 1999. Covers Series 60 Diesel, Natural Gas-Fueled, and Diesel Marine Engines. Both original white Detroit Diesel branded binders included: Service Manual Sections 1-2 and Service Manual Sections 3-29. This is the complete set, not a partial. VENT CAP / FUEL FILTER COLLAR WRENCH Large notched spanner head stamped VENT CAP, yellow plastic dipped handle. The style used on Davco Fuel Pro fuel and water separator collars, found across Detroit Diesel, Cummins, CAT, Mack and Volvo trucks. TIMING PIN Red plastic dipped handle, stepped hardened steel shaft, cross-drilled for a tommy bar, tapered pilot tip. DIAL INDICATOR SETUP, 3 PIECES Dial indicator reading 0 to 1.0 inch in. 001 increments, marked MADE IN CHINA, with an L-shaped steel mounting bracket and a separate T-handle clamp rod with threaded end. Configured for measuring cam gear backlash. KENT-MOORE PORTA-TOOL PT-2200 COUNTERBORE TOOLING, 4 PIECES Four steel pieces plus the original Kent-Moore marked bag labeled PT-2200-6. PT-2200-6 is the CB10 counterbore cutter replacement bit, used with Kent-Moore and Porta-Tool counterbore cutter plates including the PT-2250 and M50133 series. The photos show the actual items you will receive. Photos are part of the description.