For Detroit Diesel Series 60 12.7L Front & Rear Crank Seal Installer J-35686-B. J-35686-B Front Rear Crank Seal Installer For Detroit Diesel Series 60 12.7L 14. Works on Works on Detroit Diesel Series 60 and two Cycle 92 Engines. Used on multiple Seal & Wear Sleeve Assemblies including 23516969 / 23513578 / 23513485 / 23518355 / 23519651. REPLACEMENT -The tools is manufactured to OEM specifications, can be directly replaced the part J-35686, J-35686-A, J-35686-B. Made of high quality CNC heavy duty steel with black anodized finish, strong and durable. Black oxidation treatment technology, anti-corrosion, anti-rust, long service life. Used to install the front and rear crankshaft wear sleeves and seals. It eliminates lip flare on the wear sleeve and installs the seals properly without leakage. Made to properly place the crankshaft seal without leaks. Help to properly press the wear seal into place evenly. NOTE: Installing the seal uneven can cause leaks prematurely, make sure the job is done right with this installation tool. Lubricate the rubber outer diameter of the oil seal with clean engine oil. Lubricate the gear case cover or flywheel housing bore with clean engine oil. Install two guide studs (J-35686-2) through the holes provided in the center guide assembly (J-35686-1) and into two of the tapped holes in the crankshaft 180 degrees apart. Tighten the guide studs. The base must be tight against the end of the crankshaft. Install the spacers to the center screw of the base. Slide the oil seal assembly over the installer base as far onto the crankshaft hub as possible. Slide collar with the stepped side contacting the seal. Slide the installer cup over the guide studs and installer base. Lubricate the center screw of the base with extreme pressure lubricant. Install the thrust bearing with the case side toward the installer cup and install the hex nut to the center screw of the base. Tighten the hex nut until the oil seal and wear sleeve are pressed into the flywheel housing or gear case cover. When the inside surface of the housing is seated firmly against the base and spacers the seal and sleeve are properly installed. 1x Wear Sleeve and Seal Installer Kit. We are duty off on weekends and other public holidays. International Buyers Please Note. If you need to return, please double check to make sure the item does not work and contact our customer service representative, let us know the detailed problem and send us some photos for confirmation. Then get a unique address to return. We only accept return for original package, please make sure the item has not been used or installed. We reserve the right to refuse any return for any request that does not meet these requirements. Best price, quality and service. Follow us and get more promotional news. YOU MAY ALSO LIKE.